Plaster

E-MIX Plaster in use

E-Mix Plaster is designed for plastering all AAC block and brick wall varieties. The product is best known for its results and adhesion strength and is a superior substitution to conventional job site cement-sand plasters. The hardened E Mix surface can be further smoothened with a paint base and finish coat. E-Mix plaster should not be used on painted surfaces.

Advantages

    • Pre-mixed to ensure good, consistent quality.

    • Pre-packed for convenience in handling.

    • Easy to mix and apply.

    • High bond strength.

    • Minimizes cracking.

    • Excellent coverage.

    • Faster application.

    • Instructions

    Surface Preparation

    • All surfaces must be clean and free from dust, oil, and any trace of foreign material.

    • All substrate defects should be patched up before plastering.

    • Always moisten the surface before application.

    • Avoid stagnant or frequent water flow on the substrate before plastering application to prevent poor plaster adhesion on a wet substrate.

    • Mixing

    • Mix one bag (40kg) of E-Mix plaster with approximately 7-9 litres of water.

    • Mix thoroughly with a power or drum mixer for 3-10 minutes until the desired homogenous mix is achieved

    • Ensure the combination is free from lumps before use.

    • Remix for 1 minute if the mixed paste is unused for over 30 minutes.

    • Application

    • Apply the E-Mix plaster over the surface with a steel trowel.

    • If the application requires a few layers, ensure the underneath layer is dry. If and when dry, the subsequent layers can be applied.

    • Packaging

    • E-Mix plaster is packed in 40 Kg PP bags.

    • Storage

    • E-Mix plaster should be stored in a dry place free from excessive moisture.

    • If kept in a dry-covered place, the product could have up to 12 months of shelf life.

    • Health & Safety

    E-Mix plaster is a cement-based product. However, it is recommended that workers handling this product wear appropriate safety equipment. It may include dust masks, rubber gloves, complete eye protection and boots wherever necessary.
    In case of contact with eyes, it is advised to wash with plenty of water. If irritation persists, seek immediate medical attention. Make sure there is adequate ventilation and the inhalation of dust is avoided. For further information, refer to the material safety data sheet.

    Technical Specifications

    TYPE DESCRIPTION
    Form Powder based dry adhesive
    Colour Grey
    Compositions Sand, Cement, Adequate polymers and fibres.
    Recommended thickness 9 to 12 mm in each coat
    Packaging 40 KG
    Shelf life 12 months from the date of manufacturing
    Standards compliance ASTM-C926, ASTM-C897, BS EN 197-1, BS EN 998-1-2000
    PROPERTIES SPECIFICATION
    Wet density 1.6 – 1.7 kg/ltr.
    Compressive Strength >4.0 N/mm2 @ 28 days
    Water demand 17-20% by weight (7-9ltr/bag)
    Pull off adhesion strength >0.5N/mm1
    Maximum aggregate Size 2mm
    Coverage/ consumption at site 0.15-0.20 kg/mm/sq. ft

    Illuminating Sustainability

    Sustainability is imperative to contain the changing climate in a changing world. In the last few years, something has dramatically altered the worldscape, and terrible risks are known to be associated with that shift. We believe that every entity, irrespective of its domain, must contribute whichever way it can to halt the risks and protect the rest. Brand JVS is committed to making products and providing solutions that reside inside the realm of sustainability. It is our little effort to brighten up the prospect for the world of tomorrow.